A row of hot water pipes sits above the wort outlet pipe of the lauter tun. When wort filtration becomes difficult, brewers feed hot water through these pipes. The water flows back through the wort outlet pipe and the false bottom of the lauter tun and pushes up into the spent grain bed. This process loosens and lifts the compacted grain bed, and brewers call it underletting.
What Is Underletting?
Underletting is the process of sending hot water upward through the false bottom of the lauter tun to lift and loosen the spent grain bed. Brewers use it when the grain bed compacts and wort flow slows down. In short, underletting is a targeted intervention, not a routine step in every filtration.
Purpose of Underletting
The main purpose of underletting is to loosen and re-form the spent grain filtration bed, so wort filtration speed increases. Brewers also use it before pumping the mash into the lauter tun. In that case, hot water pushes air out of the space between the filter plate and the tank bottom, and it preheats the filter plate and the lauter tun. Both actions help wort filtration run normally.
Requirements for Effective Underletting
1. Use brewing water at the right temperature. Underletting water must be brewing water at 75–78°C. To meet this requirement, install a hot and cold water mixer and a thermometer.
2. Keep water pressure at no less than 0.15 MPa. If pressure is too low, the water cannot lift the compacted grain bed. Instead, it only permeates through the bed, and the underletting effect is poor.
3. Use underletting sparingly when filtration runs smoothly. If wort filtration goes well, avoid underletting or use it as little as possible. Each underletting operation brings a large amount of water into the wort. Moreover, pushing water up from the bottom is far less uniform than sparging water from above, which is not good for washing extract out of the spent grain and hurts raw material utilization.
4. Watch the grain bed surface to judge the effect. During underletting, observe through the manhole on the lauter tun. If the liquid surface above the grain bed rises in several spring-like surges, the underletting effect is good. Underletting usually lasts 3–5 minutes, and whether to run the raking machine depends on the situation.
Why Underletting Matters in the Brewhouse
Underletting matters because it directly affects filtration speed and brewhouse throughput. When the grain bed compacts, wort flow drops and filtration time stretches longer. In short, a well-timed underletting restores flow and keeps the brewhouse on schedule. However, overuse brings extra water into the wort and reduces extract recovery. That is why brewers should treat underletting as a precise tool, not a default action.
Underletting sends hot water upward through the lauter tun false bottom to loosen the spent grain bed and speed up wort filtration. To use it well, brewers should use brewing water at 75–78°C, keep pressure at no less than 0.15 MPa, avoid unnecessary underletting, and judge the effect by watching the grain bed surface. When handled correctly, underletting becomes a reliable way to restore wort flow and protect brewhouse efficiency.

